Bucket paint job!oh fun

Mirax H said:
Clean your airbrush and make sure you have a good seal with the air and enough pressure.

I second that, That was a big problem with my crapy air brush gun!!!!!!!!!!!

Matter of fact read this

might help some
 
ok well i acctualy cleaned them after i noticed the problem. ran some thiner throught them, then some water. so i jst need to find the paint and try again,
DOES ANY ONE KNOW WHAT COLOR TO USE FOR JANGOS LOWER MANDIBLE AND RF? sry bout the caps just trying to draw attentino to that! lol. ok well report back later
 
This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top