BKBT Jango Thighs

I have both left & right pieces rough trimmed & will probably get the final trim done tomorrow. Hopefully I'll be able to mold these on the weekend. The finished height will be about 11" which I concurred with Donny's measurments. If you are under 5' 7" you could trim the armor a bit if needed. If you are 6'+ the armor should still fit fine, just watch the spacing of your pieces & position them farther apart.
 
Here is a new round of pics. The armor has been further trimmed & I can see a couple of areas that I need to address still. The top needs to rounded a bit more as well as the side. Again, others eyes are welcome. Sometimes you can get to close to a project & be blinded to details that are obvious to others.

DSCN1653 copy.jpg


DSCN1654 copy.jpg


DSCN1655 copy.jpg


DSCN1656 copy.jpg
 
Just a quick update: The thighs are molded & the jacket mold will be finished tomorrow. First pics of the first pulls should be up on Sun. I have a few people to "take care of";) & then I'll do a small run of these to finance the materials for the shin armor.
 
Pics of the first test pull from the molds. These are now ready to go & I'll start casting up sets right away. There are a couple of people I need to take care of first & then I'll be posting a thread in the Cargo Hold.

TDH1 thigh.jpg


TDH2 thigh.jpg


TDH3 thigh.jpg
 
This thread is more than 16 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top