Trimming FP v.3 armor.

Hi guys.
After a long postponement on my fp v.3 armor trimming, i have now dared myself to start the trimming process. In my first attempt i marked the inside of the chest armor plate with a pencil, i set the mark at 3mm (1/8" i think). I looked at the reference material that i have, but none of them shows the back of the armor. I have the feeling that my armor needs to be trimmed down some more, but i don't want to do it before i can confirm that it is supposed to be less than what i have.
Is there anyone out there that could take a pic of their inside armor piece so i have anything to compare mine to?.
I'll post my attempt.

Looks pretty good to me bruv, I have seen some that leave too much on theirs?
If you look at the ref material it does not look very thick, so your onto a winner IMO...

btw... I have FP V3 armour

Originally Posted by Mojo-Fett

Looks pretty good to me bruv, I have seen some that leave too much on theirs?
If you look at the ref material it does not look very thick, so your onto a winner IMO...

btw... I have FP V3 armour

I know that you have that baby.
I got it just before you

Very nice trimming! If you need any help, check out my YouTube videos.

http://www.youtube.com/watch?v=-oSpljgtHz4
http://www.youtube.com/watch?v=WXfeZ-vUzKw

Originally Posted by GCNgamer128

Very nice trimming! If you need any help, check out my YouTube videos.

http://www.youtube.com/watch?v=-oSpljgtHz4
http://www.youtube.com/watch?v=WXfeZ-vUzKw

The funny thing is, that i am watching it right now as i got this notification.
Thanks Andy.