Sintra made flame thrower

I have recently made this flame thrower for my gauntlets. It still needs to be cleaned up.
<img src=http://200.72.163.179/cdref/tdh/Armor/sintraflamer.jpg>
<img src=http://200.72.163.179/cdref/tdh/Armor/sintraflamer2.jpg>

Nice job man

Can't wait to see the rest


~Bobby

Looks cool!

Looking Good!

Loranar

Very nice job Phantom Viper!!
Is there a bottom on those yet? How did you make it? I'm going to have to make this piece for my sintra jango gauntlets so any info is appreciated.
Thanks.

Thanks guys

There is a bottom on the longer body but I have yet to put a bottom on the end piece. I first made a template on my computer then printed it out and laid it on the sintra sheets and traced them with a box cutter. I had to do some trimming to the pieces to get them to fit evenly. I forgot to compensate for the . 120" thickness of the sintra when making the templates. But it was not that hard to trim the pieces to fit. For the main body I glued the top and bottom pieces in between the side pieces and for the end emitter piece I glued the top and bottom pieces on top of the side pieces. That way the emitter fits in between the main body for a good fit. I did have to trim the emitter piece to make it even with the bottom.But i have now changed the template so you could glue the top and bottom emitter pieces in between the sides. I used super glue to glue it together. That was a pain in the but. I glued my fingers together a few times before I was finished After I got the pieces together I used a glue gun to reinforce the sides. You may use the templates if you wish. If you have any other questions feel free to ask and i will try to answer as good as i can

this is what i mean by in between
<img src=http://200.72.163.179/cdref/tdh/Armor/flamer.jpg>

Here is the templats with some mods. so hopefully it will be easyer to use.
<img src=http://200.72.163.179/cdref/tdh/Armor/flamethrowertemplate2.jpg>