Printable View
Ok so here is the closest I've gotten right now with the armor. I'm currently working on my vest and my helmet and some metal armor but when I held this up it looked a little off. I figured I'll make the collar bigger but other then that I figured I would ask around and get some opinions on it. I used the medium armor sizing due to hight but I wasn't sure if maybe I should go up one to the lower end of the large or what. Any suggestions?:skull
It doesn't look all that much off, perhaps just a tad on the big side. It's really difficult to tell from the picture. But I would certainly not go any bigger.
Are you making this Boba armor, Jango or a custom?
I not really sure... most likly Boba, but I'm also planing a mando-variant as well. I know it will be a tad smaller once I sand it. I'm thinking the collar is to small at least on the parts that go over the shoulder.
*whoops... double post* :doh
Please keep in mind that the shoulder armor should be the same width as the chest plates.
Your best bet, at least this is what I did, is to use the ab plate as a gauge, then base the rest of the armor plates from it. Keep in mind that there should be a consistent 1 to 2 inch gap between the plates. :b
Another point to keep in mind when sizing your ab plate, is that it should sit above your waist/girth belt ( not covered by the girth belt at all ), this will aid you in finding the correct size for your body size. :cheers
Awesome! I'll make sure to keep that in mind. Thanks.