WIP - Scratch Built RF

Updated photo.

RFPic33.jpg
 
Hey!

These look GREAT! If you do start offering them please consider me - Ive no RF or stalk so these could be just the ticket!

Very impressive pics with the two side-by-side - cant wait to see the process!

Dave
 
I knew that would work for ya;-)
I'm a dental tech by trade and i work with different resins and dental acrylics all day and a pressure pot is the key to an excellent casting.
They look awesome!
 
Can you tell me roughly how much these weigh.
I'm researching a lightwewight rangefinder 'cos my stalk is cardboard. I was originally just going to have a shell but it would be nice to have the clear part and everything else in there.

ty,
Tom
 
Can you tell me roughly how much these weigh.
I'm researching a lightwewight rangefinder 'cos my stalk is cardboard. I was originally just going to have a shell but it would be nice to have the clear part and everything else in there.

ty,
Tom

With all 3 parts, they weigh about 1.8 oz.
 
Hey asok!

Got my parts yesterday! WOW - just WOW!

Beautiful casts! At some stage I must post about the first ever cast part I bought, an E11 Blastech and what a POS it was... set me up for thinking all casts required major surgery - how wrong I was!

Absolutely beautiful RF (and MQ1) - worth twice what your charging! AND I dont know how you got it from the states to ireland so fast!

If your EVER doing any other parts Im in :) Great work!

Thank you very much!

Dave
 
^^If you have a hobby shop near your house you can buy small square aluminum tubing for about a buck for 10 inches of it. It works great as a cheap way to make a hollow, aluminum centered range finder stalk. I used an alum and 2 brass on my first one. And although its not great, it suffices.
 
Dave,

Happy you like them. I have gotten stuff that needed so much filler it was crazy. When I make something, I make it for me and my standards. Then just hope others like it as well. :D The only item I do not like about the pressure pot is that is can be extra flashing.

Other parts, well, I did the ROTJ baster and MQ-1 parts. Again, I will need them for my blaster and just hope others can use them as well.

Not sure what I am doing next.
 
What were you using for your initial model? It looks like cardboard and resin, but not sure. I've been working on another project (the concussion grenade launcher) with foam board and I was looking for alternative materials due to the fact I would have to coat everything before casting.
 
This thread is more than 14 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top