Visor question.

Adoo

Jr Hunter
Hi folks
I have ordered some 3mil dark frosted perspex, was only cheap but im not sure how to cut or shape it.
Im guessing a hacksaw would do to start and then trim up with the dremmel.
How would I then make it pliable enought to bend to shape?
Thanks in advance.
ADAM
 
This thread is more than 13 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top