Visor mandible width

well, I've actually sat down and messed with my DP95 that I stripped last year. I drilled a whole in the upper center ridge in order to center the visor. I've also cut a brass ring in halfe to glue into the back to give it the proper flair. The question I have is, how far apart should the 'mandibles' of the helmet be? The bottom of the T, the part by your jaw.
 
Last edited by a moderator:
The bottom should be the same as the top. Pull the top in/out to match the helmets brow line at the top, then whatever distance that is to match the bottom, if that makes sense. The whole visor area should be flush so the visor fits right.
 
This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top