Uncut Tvisor?

Luis

Luis

Hunter
Has anyone ever purchased the Uncut visor from T-visor?

I just want to know if the uncut version still has the semi circle curve.. I wouldnt want to get a flat lens ;D

The visor I ordered for my fang bucket leaves no room for screws or bolts that I can attach on the sides of the mandibles....

Thanks!
Luis
 
if you check out this pic (Boba Fett Costume - The Dented Helmet Gallery) from the MoM exhibit, you can see that there appears to be a piece of bent copper that has been puttied onto the lower cheek and then there are thumb screws that hold the visor flush with the mandibles just by pushing it into place. so if you're going for accuracy you don't need screws to go through the visor.
 
Dang! Thanks for the tip!! I'll go for that setup instead :D


saint_nasty said:
if you check out this pic (Boba Fett Costume - The Dented Helmet Gallery) from the MoM exhibit, you can see that there appears to be a piece of bent copper that has been puttied onto the lower cheek and then there are thumb screws that hold the visor flush with the mandibles just by pushing it into place. so if you're going for accuracy you don't need screws to go through the visor.
Click to expand...
 
This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top