Silicon mould Question

DegaX

New Hunter
Hey Guys just wanted to say hello.

I'm vary new and me and my buddy have been working on a boba fett cardboard helmet and we wanted to try and make a Silicon mould of it, our question is after we get the mould made, We are going to try and recast it in resin for our selfs so we dont mess up the original lol, Now how would we go around casting the resin one? How would we make it empty in side so we can wear them? Any help would be great thanks
 
slush-cast it... look around U-tube, there's lots of great how-to videos on this sort of thing. :)

yup, i've been learning that fine art myself.

you slosh it around until the resin gets solid. it takes a couple of layers to really get it right.

i'm using smoothon.com's smoothcast roto and it seems to work wonderfully.
 
This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top