Servo advice

Darth Tuapawa

New Hunter
Hey guys
Just after a bit of advice from you Mando's with remote control Rangefinder set-ups. I'm in the midst of making an ARC Clonetrooper and want to control the movements of the RF via a switch in my gauntlet.
I've found what I think would be a suitable servo (small enough to fit in my helmet but powerful enough to lift the stalk and rangefinder) but seeing I know absolutely nothing about servo's (and the shop doesn't seem to be to much help) I thought I'd ask the experts :)
Bear in mind I'm situated in New Zealand so getting a servo from this website will probably be my best bet.

http://www.the436modelshop.com/item_detail.asp?id=3710&category=227

Cheers and thanks in advance!
- Darth-Tuapawa
 
This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top