self moving rangefinder

bpwmd

Hunter
ive been making my pepakura fett helmet and am waiting for the weather to turn so i can resin it. so i have been working on the problem of moving the rangefinder.hoping one of you can help. i dont wanna use any of the expensive circuit boards. this is what i came up with. tell me what you think and if it will work
sorry for the poor drawing.

boba fett range finder circuit.png
 
I'm not sure if it will work. You will need power to run through both sides of the motor. The best way to test it is to set it up on a breadboard and see what happens.
 
I would try eBay. Sites like Newark.com and mouser.com sell them too.
 
This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top