Rubies 97 visor

deadite99

New Hunter
Ok...I know the infamous Rubies 97 Isn't the best helmet in the world but I figure it will be a good starting point .My question is,does anyone know what kind of adhesive is used to glue the stock visor in place,it seems to work pretty well because I cant seem to pry the sucker out.Ive decided not to cut out the old T visor and just install the new one through the front so as not to lose what little strength the helmet already has even though I have already fiber glassed the inside.Ive already cut and sized the new visor and it fits very well and looks nice,I just need a good strong and transparent glue that will not show through the visor....Thanks in advance for any help.
 
Try to find yourself a 2002 Rubies Jango Fett one piece. I have one, and boy is it better than the '97. If you want a cheap Boba or Jango, that's the way to go.

For the visor, just dremal it out and replace it with this. Anchor Brand - Face Shield Visor, 15 1/2" x 9", Dark Green, Unbound, Plastic: Safety Equipment & Gear : Walmart.com I have like 20 of the and they're amazing. Why pay $20 for a welder's visor when this works just as good? Stick it I the oven at 400 for about 2 minutes and form it to shape. Just don't take off the plastic film until after you shape it. JB Weld it in place, and BOOM. You'll have once heck of a nice start, my friend.
 
This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top