ROTJ - MS3 #13 FINISHED

KidAkira

Active Hunter
Here's my MS3 #13 ROTJ Bucket, I finished this a while ago but had lent my camera out. So unfortunately no progress pics.......
I used the masking method to paint it up layer by layer and used toothpaste to mask off the battle damaged areas.
The paints used were all Tamiya Colour spay cans.
Dome + Cheeks - Olive Green (USAF) - AS-14
Upper Cheeks - Dark Green - TS-2
Back - Racing Green TS-43
Mandibles - Dull Red - TS-33
Silver Undercoat - Silver Leaf - TS-30
The only other spay can colour used was an Australian brand green which i used to lighten up the dome and cheeks a little - White Knight Touch up paint - Rivergum.
All the weathering was done with washes, dry brushing and sponge stippling using acrylic paints.. I don't use an airbrush for weathering as i think it looks a little to uniformed and misted on.
The whole thing was finished with Model Master Lusterless (flat) Lacquer overcoat.
It also has a Hyperdyne labs remote RF servo installed, and a BobaMaker ROTJ deluxe RF + hollow RF stalk. (Both highly recommend)

Feedback, comments and questions welcome
Cheers
KidAkira
h1.jpgh2.jpg
h3.jpgh4.jpg
h5.jpghs.jpg
h8.jpgh6.jpg
 
Thanks for the kind words guys. The bow in the visor / mandibles is exagerated in the photo's... There was only a very slight wave in the mandbles on the sculpt. Also the red is a fair bit brighter in the pics but could use a bit of darkening /dulling down
Cheers
KidAkira
 
This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top