RF Stalk size

gymbeau2000

Active Hunter
Ok, so I bought an aluminum stalk from a great vendor on here and it's a beautiful part. However, when I took off my resin one and test fitted my aluminum one, it just didn't look right. The aluminum one is much shorter. So after doing some digging around without success, I figured I would make a thread and pose the question - how long is your RF stalk? Also, how long should it be? I have a SGTFang for reference.
 
I measured the Rangefinder Stalk that I made for my helmet templates (I used reference images from the Gallery to achieve good proportions) and the result is this:

RF Stalk Measurement.jpg

I hope it helps.
 
Last edited by a moderator:
Anybody know the width that the RF Stalk needs to be? Because I may have to shave mine down quite a bit to fit right in the ear caps that I have. I've been contemplating buying new ears all together, especially if I wanna upgrade and get an aluminum stalk.
 
Anybody know the width that the RF Stalk needs to be? Because I may have to shave mine down quite a bit to fit right in the ear caps that I have. I've been contemplating buying new ears all together, especially if I wanna upgrade and get an aluminum stalk.

You'll find all the measurements you need in this thread ==> Rafal Works Helmet (RWH) v2 Helmet Templates and Build at the end of the first post and at post #32 (the rangefinder).
 
This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top