RF Lights install help

Hey Guys, I need some advice on installing my new Mrg8ness lights into my RF. I have a Terminal Fettler RF and know I will need to Drem the lens block a bit after I've got the board in but thats the problem I cant seem to fit the board into the RF. If anyone has the same setup is it possible to post some pics? It just seems too wide to fit and I dont want to break either of them in trying to fit it in.


Thanks in advance!

I have recently had the same issue.. a good mate of mine adapted it a bit so the board now sits in the lid whilst the LEDs and tilt sensor remain in the topper... no need to dremel anything either. he currently still has my lid till I can get over to see him.. can get pics over then...unless someone else here beats me to it.

Thanks mate it would be good see how you set yours up but I have a self-contained unit as well which will make any altering hard I would think. Hopefully someone can help out.

Quote:

---

Originally Posted by TK6540UKG

I have recently had the same issue.. a good mate of mine adapted it a bit so the board now sits in the lid whilst the LEDs and tilt sensor remain in the topper... no need to dremel anything either. he currently still has my lid till I can get over to see him.. can get pics over then...unless someone else here beats me to it.

---

I would give salamanderking a pm, his rf light kits are very small and should fit in any rangefinder.