Resin vs. Resin+Fiberglass

CSMacLaren

Active Hunter
In another thread there was a request that a certain helmet kit be offered with fiberglass.

Now with resin, if you drop it, it'll crack, and the cheek plate might even break off.

With fiberglass, you're still going to deal with a crack, right?

Is there some added advantage to having something made out of FG?
 
Hey bro,

Resin + FG [Pros]:
1. Should you drop the part and it cracks, it can be repaired by bondo and sanded down. I did that with my BP ROTJ Gaunt shell. :)

Resin + FG [Cons]:
1. It's got weight if it isn't done properly.

Hope this helps a little.

Stay safe,

Tim.
 
Fiberglass makes it stronger, its also accurate. But adding Fiberglass to resin isnt the best way to do it. A good fiberglass helmet has a gel coat on the outside. You can do the same with resin aslong as you coat it with fiberglass while the resin is still curing so the two bond. Other wise there is a chance the fiberglass can detach.
 
This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top