Removing Super Glue from visor... HELP!

darksidedesign

Active Hunter
I thought I could apply some Super Glue in small amounts
around the visor without getting any on the front of the
visor... I was wrong.:facepalm

Now I need some pointers on the best way to get this crap off.
There isn't a whole bunch and it's barely noticable, but it
bugs me. Any ideas?

Please help!

darksidedesign
 
Your pretty much screwed. You can try super glue remover. If that don't work, you can try and sand it down and plish the scratchs out. That is what I had to do on my 95.

Lynn
 
Last edited by a moderator:
If that doesn't work, you can try using a Dremel with a polish wheel. Press very lightly on the affected area. It should remove the glue without scratching the visor. If you press too hard, however, the wheel might actually cut into the visor, leaving a permanent gash. I know from first-hand experience. :facepalm
 
Try Nail Polish Remover.. I used it on scale models in the past. But to be fully honest I have never tried it on clear parts. Test it on a scrap piece then try to follow through with what Rammage had suggested.
 
This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top