Rangefinder LED's logistics question.

My range finder is hollow and my stalk is solid. I will be dremeling a channel in the stalk inserting 2 wires then filling channel with Gapoxio. The Gapoxio will make it stronger than it originaly was.
 
Same place as TK inside the ear deali. I made the switch for the light a little different I put one battery terminal on the stalk, and one on the bottom of the ear piece where the rangfinder rests.

now when I pull the stalk down the two terminals make connection and the lights come on.
 
This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top