Rage Finder Servo question?!!! need help, PLEASE!! =)

L

Lucas Alvarez

Guest
HI everyone!

I use a -Hobbico- Micro Sub Servo in the rage finder but I think the range finder is heavy for the little one!!!

My range finder is a mixture. The top is from a regular Don Post ( the plastic light one, with empty inside ) and the stalk is a custom aluminum that´s only one inch large than the regular Don post. I add an inch because the regular DP stalk looks to short to me. The helmet is a "Mistery" one.

WHICH SERVO ARE USING FOR THIS STUFF?
Also i need some ideas to fit the servo in the helmet.
If you have pic´s please will be better!!!
Feel free to mail me to:
[mail]lucasalvarez@ciudad.com.ar[/email]

Thank´s in advance!

Lucas Alvarez
Tk/Tb 2111
 
Transmiting in the old imperial code....!!!


010 10101 00101 01010 Hola!!

...Translate 0100101 0101 ...Hello!

End transmition!!!!

=)
 
Gracias por la bienvenida!!!
Soy miembro de hace rato pero no muy activo =P

Me gusta lo classico y por ende Boba Fett es lo mas!!!

Salu2

Lucas
 
I used a servo that i picked up at the local ACE Hardware that just happened to carry model airplane parts(go figure)and the name and model number escape me, but the micro car directions that were posted somewhere on the board didn't work for me since i'm not what you'd call an electronically inclined genius(hack artist is a much better description)I also used the circuit board from a larger R/C car that i got at Wal Mart and ran the servo and RF LED's into an on/off switch and use a 9V to power everything together....Frankenstein meets Boba.....
 
This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top