Quick blinking LED question

Jgbeerman

New Hunter
are the LEDs found in the range finder specific blinking ones or are they just regular LEDs that happen to blink based on how they are wired?

my only experience with LEDs was a simple hookup to a tortoise switch for my model train layout.

Thanks for any information.
 
They blink because of the circuit they are in. There are a few different ways to get them to do it. A few members make kits that you put in the RF.
 
This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top