question about boba dlx visor

  1. #1

    question about boba dlx visor

    Im redoing my jango fett helmet which use to be a 1st gen cast of a dp deluxe. On the visor area, there is a groove, where Im assumming that the original clipped in. Should I dremel it down or should i bondo it and sand it?
    the key is to make sure its even, correct?

  2. #2

    Re: question about boba dlx visor

    The DP deluxe Fett did use two semicircle grooves to secure the visor. They later filled in the grooves to cover them up.

    Bondo and sand.

  3. #3

    Re: question about boba dlx visor

    thanks tyler!
    man i bought this helmet prepainted and there is tons wrong with it. i can see the visor grooves just glancing at the helmet. its a shame when you pay extra to have something done right and you come to find out youre better off doing it yourself.
    thanks again tyler

Similar Threads

  1. Helmet T-Visor Question?
    By Mister Hyde in forum Boba Fett Helmet
    Replies: 7
    Last Post: Feb 11, 2010, 12:19 PM
  2. Question: Installed visor question
    By AncientFett in forum Boba Fett Helmet
    Replies: 4
    Last Post: Jun 30, 2008, 1:05 PM
  3. T-visor question
    By aguma in forum Boba Fett Helmet
    Replies: 6
    Last Post: Sep 17, 2006, 5:03 PM
  4. VISOR COLOR QUESTION
    By Benkenove in forum Boba Fett Helmet
    Replies: 3
    Last Post: May 6, 2006, 7:43 AM
  5. Visor question ?
    By FettTheHunter in forum Boba Fett Helmet
    Replies: 3
    Last Post: May 30, 2005, 10:47 PM
  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •