Paint question?

Delta9

Hunter
Wasnt sure where to ask this but I've painted a helmet with rustoleum protective enamel paint and I wanted to buff the hard lines where the paint is uneven, I have a dremel with the buffing tools but should I use a compound or water or what?
 
Delta-9 said:
no I mean where I masked off areas, I just want to soften the line without misting it with anything.

If you have a little raised ridge where 2 colors meet, you can try a Scotchbrite pad or some very fine sanding film, but be reeeeally careful until you get a feel for how much pressure to use.
I'd practice that technique on something first.

I would think if you used a buffing wheel, even at a relatively slow speed, it would be too hard to control.
 
Thx everyone the 2000 grit sandpaper worked perfect.

C6F07729-CC6D-2637-DF99D67CE72AD5B4.jpg
 
Last edited by a moderator:
This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top