Opinions please.

Okies,
Had an accident with a table saw at work so no fabrication on the ears, However.....I've been painting a little and I took the masking off the visor -well, I'm not sure if its the over exagerated flair throwing it off or not, but does the visor look too narrow??. I like the squintiness but I'm not so sure about the width of the vertical part of it. Thanks for the input.

Josh

visor1tq.jpg
 
WOW!!!:eek: THAT is unreal! I wouldn't worry about the vertical part of the visor. It's not a big enough deal to mess with. I personally like the narrower vertical part. I'm getting the itch to try and scratchbuild a bucket myself. Your creativity is rubbing off. Keep up the good work.(y)
 
Last edited by a moderator:
WOW...Josh this looks amazing.....:eek: :eek: :eek:

When are you going to cast all of these scratch built ones up already???

And I think the visor looks fine....

Colors look great too..

I want one.;)

Kripps said:
Okies,
Had an accident with a table saw at work so no fabrication on the ears, However.....I've been painting a little and I took the masking off the visor -well, I'm not sure if its the over exagerated flair throwing it off or not, but does the visor look too narrow??. I like the squintiness but I'm not so sure about the width of the vertical part of it. Thanks for the input.

Josh

visor1tq.jpg
 
Last edited by a moderator:
This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top