Need help with T-Visor

i have i think a mystery helmet. (it fits my head and i am 6'3, 235lbs) my problem is getting the actual visor in there. i have made a semi-lip for it but was wonder is there a better way?

laso looking for a left side gauntlet. Any help?
 
Did you guys cut down your visor so that it just fits? Seems it'd be much easier to make it fit, and you'd have more room on the inside to place your fans. Has WizardofFlight made a template sized for Mystery helmets to help you know where to cut and make a more neat package inside? It'd be cool to have one before I go hacking into my visor...

 
I used the Tk-409 epoxy putty method, with Duct tape over the putty to hold it in place while it hardened. i didn't have to cut my visor, i have a MS, I just ordered an XL visor from T-visor.com on ebay. Great buy, I reccommend
Helmet-interior.jpg
 
This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top