My Scratchmade RangeFinder

So I know it isn't screen accurate but I was thinking it would be neat to put a small wrist watch sans strap into the range finder so when you put it down you can see the time. Helps you get to those convention events on time :)

Thoughts?
 
You could really go wild with the usefulness of the rangefinder...especially if you rigged it with swappable units. You could have a camera (one of those tiny digital key chain cameras pointed out the front (when the RF is down) so you could take pics of an event...or a digital thermometer or the watch or a host of other useful small portable electronics.

Or a small mp3 player hooked up to speakers in the helmet? :)

I mean, it's a costume but the helmet is the most bad@$$ part so why not rig it up with all sorts of neat stuff?
 
great stuff... just what i was looking for actually :) (well, just a stalk as i have an rf unit already)

Do you think this would be good for an ARC trooper?
Will it hold up to the stresses of a motorized unit?
 
That's coming along great!

I can't cast in resin for ****, so mine's likely to be a one off :lol:

I'm still (only a few minutes ago) working on my scratched one; finally getting to putting the individual lens cuts glued into place...
 
This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top