My ROTJ Bucket

So.. long time no see... I "finished" this bucket about a month ago but with an infant at home even the smallest of tasks can take the longest of times..

So here it is... in all its glory and faults.. my finished BM ESB helmet.. painted in a ROTJ style and with an ESB Fettronics stalk, rf and Servo Controller board.

Smallpic_007.jpg


Smallpic_008.jpg


I've installed rare-earth magnets on the right ear to be able to dissasemble the RF for transport if needed. Trying to move away from the leathal Frankenstein bolts i had in my old helmet..

And i just realised that i've forgotten to paint the red on one of the "turn signals"
Smallpic_010.jpg


the back
Smallpic_011.jpg


And a close up.. i've installed a resincopy of the MQ-1 Circuit board..
Smallpic_012.jpg


Smallpic_013.jpg


And a few two close-ups of the cheeks.. really proud of the effect i got.. still need to add som silver here and there though..
Smallpic_014.jpg


Smallpic_015.jpg


A shot of the top of the helmet..
Smallpic_017.jpg


Interior shot 1
Smallpic_019.jpg


interior shot 2. Showing some of the circutory of my Servo controller board and servo which makes the RF go upp and down
Smallpic_020.jpg


i hope you enjoyed the pics..
 
This thread is more than 14 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top