My Progress, plus a little help...

N

Nos Ir RaH

Guest
Hey guys, I wanted to post some pics of my "Desert Mandalorian Armor", here's a link: http://f1.pg.photos.yahoo.com/ph/thereverendh/lst?.dir=/Fett&.view=t

Also, I boought a T-Visor like this one on e-bay: http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&item=2195567558&category=154

I'm having a bit of trouble figuring out how to make it fit. Do I need to heat it and bend it? Should I dremmel the top to make it get in the visor area? And what is the best method for attaching? I have epoxy that I was going to use on my hard hat assembly, will that work well?
Thanks
~Nos
 
i used duct tape to hold it in place, then put putty on it to hold it for good, waited an hour then took the tape off. You can also drill it in, but i dont kno how to do that.
 
This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top