MY NEW HELMET!!!

GrottyFurball

Active Hunter
Hey guys, just letting everyone know that my new Terminal Fettler helmet arrived the other day. I tell you guys TF is a TRUE craftsman everything on his helmets are nice and clean. In the picture of the interior of the helmet, it's MY shabby temporary wiring. The only modification I plan on making to this helmet is fulling the left ear cap with some clay or something to counter balance the rangefinder.

our cross country trip 088.jpg


our cross country trip 089.jpg


our cross country trip 090.jpg


our cross country trip 091.jpg


our cross country trip 093.jpg
 
Last edited by a moderator:
Ok so I have my hard hat liner and ready to put it in, I'm going to go the velcro route but I need to know what kind of glue will keep velcro attached to nylon? Or am I bound to sewing it on?
 
my liner has plastic tabs that I put the industrial velcro on. It stays just fine. I will see if I cant take a pic of the inside of my helmet and post so you can see.
 
Yes TF painted it aswell.

On my liner there's 4 tabs that bend over the main "brim" I guess you would call it so I don't really have anything but the nylon fabric to put it on.

our cross country trip.jpg
 
Cut the nylon off... it will make more sense when I post a pic but I folded the plastic tabs over on them selves and placed strips of industrial Velcro on them and they hold just fine. The job of the liner is to act as a stabilizing device, not to gold the helmet up. You will want a removable piece of padding on the center of the dome for holding the helmet the correct hight.
 
This thread is more than 16 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top