My finished helmet (BIG pics)

BobaN00b

Active Hunter
except for the visor and i have to cut the heads off the screws the visor will use. i am happy with it. may not be the best, but it's my best, lol. thank you tdh members for the help and insight:



a.JPG

b.JPG

c.JPG

d.JPG

e.JPG

f.JPG
 
Nice job!(y)

Any reason why you didn't bondo over the stamp marks for lucasfilms ltd etc?
And is the left ear piece cut open down the centre???

Mason.
Ps: I think you pic's will be resized by the authorities in the very near future...
 
Master-Jedi-Allma said:
Any reason why you didn't bondo over the stamp marks for lucasfilms ltd etc?

Heh. I forgot about it actually, lol. :lol:

Master-Jedi-Allma said:
And is the left ear piece cut open down the centre???

For ventilation. I will place some fans in this soon.
 
Jun Garros Fett said:
Looks good. (y)

How did you cut out the slot in the left ear?

I used the same dremel. You can see where it slipped a few times. So, if you use a dremel, do it slow, lol.
 
I also cut the slot out of the left ear and then put mesh over it from the inside. I think it is a good way for ventilation, as stated by BobaNOOb
 
This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top