My ESB Amatuer Paintjob

Jodo Kast 2749

Active Hunter
Here's what I started with:
77_12_s.jpg


This is the MLC modified DP97 recast. I bought it from a fellow board member - I assumed MLC meant MLC-1 and he assumed that since MLC made it, it was a MLC. It's a nice helmet but not quite enough room with my glasses on. He's been super cool about the whole thing and offered a full refund if I don't sell it but I decided to paint it up and give it another try.

Here's my paint job:


35_3.jpg

3e_3.jpg

9f_3.jpg

Note that I reworked the front "turn signals" and the dent. A little bondo and some sculpting with a sharp knife, et voila!
IM000266.JPG


I wanted to get it done to see what the colors looked like together. I used all spray paints - I can list my colors if anyone really wants them. If/when I finally get a extra large helmet, I'll take a lot more time and really go for accuracy.

Feedback / advice appreciated.
 
the kill stripes are up a bit high on the bucket jodo my friend. other than that, nice work - should help this bucket sell on eBay (lets hope!)
osk
 
Thanks Obi Sean, I messed up with my template and masking for the kill stripes (thanx TK-409) and put them too high.

It's a nice helmet but just too damn small for my peanut! :(
 
This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top