Movie sized bucket question?

tteF aboB

Active Hunter
Looking down from the top at the front of the helmet the cheeks seem to stick out. What has been done with this if anything? Meaning are you torking it in a little then securing the visor or just placing the visor and does this look OK.
 
Has anybody tryed making some what of a Holding cell for their Visor inside your Helmet? (that sounds stupid) Something like a Slide in - Slide out Visor. So incase you wanted to take your visor out & change it, or even clean it?

This may just sound like ???????????????? but I'll try to draw out some sorta sketch for you to go by -
 
Fettish Fiend cut a groove into the area so that the visor sits closer to the front. Conceivably it could be installed and removed very easily.

I like the idea of it but it would be alot more work than I'm prepared to give lol... Too much headache for me worrying about lining it all up right. I prefer to rearmount the visor because it doesn't have to be cut precisely. If you frontmount it or otherwise create a channel for it you will need to cut the visor precisely. Too much and you need a new one :(

Phil
 
Jaster,

The visors on the real deal were held in using a sort of a bracket and screw method. There should be a couple pics around here of it. It looks like the visors on the originals could be removed and replaced.


Jaster Mereel wrote:

Has anybody tryed making some what of a Holding cell for their Visor inside your Helmet? (that sounds stupid) Something like a Slide in - Slide out Visor. So incase you wanted to take your visor out & change it, or even clean it?

This may just sound like ???????????????? but I'll try to draw out some sorta sketch for you to go by -
 
This thread is more than 21 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top