LEDs in Rangefinder??? Here is PROOF!

  • Thread starter Migrate from As You Wish
  • Start date
Originally posted by Skaught77:

Where do you get a mercury switch - besides from an old thermostat? Price?

Scott



rl_rebel_logo.jpg

banner_002.jpg
richiebannersm.jpg
[/center]
 
Last edited by a moderator:
Originally posted by Lynn TXP 0369:

"Where do you get a mercury switch - besides from an old thermostat? Price?"

Ebay... I just got mine yesterday, $5.45 shipped. Just type in mercury switch. When I won mine over a week ago, the guy had a ton of them listed....
Lyn
 
Originally posted by TK0000:

The LEDs blink in a (LOOP) cycle of sorts: 4 times at the same time, then they look like they're going an upward direction 4 or 5 times, then back and forth 4 times, then in a downward direction 4 or 5 times, then loops back to the begining, blinking at the same time.

They really arn't that bright. At a certain angle they appear to be brighter.( the angle of the picture in a low level of light) Bright enough to see in a lighted room or in day light. The flashes are faster than I would prefer, but untill a circut is available this will work great.
 
Originally posted by TK0000:

5mm
Blinking Red LED
RS Part #: 276-308
Clear lens
 
Originally posted by ShackMan:

Hey BB, that was an unanswered question I had for you. What size LEDs were you wanting to use ... 3mm or 5mm?

Thanks,

ATM

Rapier wit? This is the end of the twentieth century! I'm using a laser sighted under-and-over twin barrelled wit, with a 7.62 mm floating breech pulse rifle firing caseless one-liners on top, and a 40mm explosive gag launcher underneath. For backup I've got a 14mm pump shotgun firing flechette rounds with 10 barbed comments in each, which can also shoot sabot ego-piercing rounds. Of course when all else fails, there's always the trusty flamethrower which I've strapped to my pulse rifle with duct tape in the approved style.
 
Originally posted by TK0000:

I should clarify that the holes for LED’s drimmeld out with a small ball tip from the inside out after a very small hole was drilled with a drimmel. Only the tips (about 4mm) of the lights show through the faceplate.

I have extra tilt switches.
2 switches for $5.00 + shipping.
I have 3 sets left.

Paypal OK.
TK0000@fanforce.net
 
Originally posted by Skaught77:

The ones I bought look like small light bulbs - glass. I figure it would have to be glass or plastic.

Scott



rl_rebel_logo.jpg

banner_002.jpg
richiebannersm.jpg
[/center]
 
Last edited by a moderator:
Originally posted by TK0000:

They are the small glass bulb type. They almost look like an LED. You can see it in the pics right next to the LED's. If you want a couple let me know.
 
This thread is more than 22 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top