LED wiring question...

Thread starter gunnerk19
Start date Mar 4, 2009

gunnerk19

Active Hunter

Mar 4, 2009

OK, for my RF I've got 1 red blinking LED and one clear green LED, both connected pos to pos, neg to neg...

When I hook up a 4 x AAA battery pack with the supplied wires they work as they should; when I add a length of wire (with the right polarity) to run thru my RF stalk to the pack, they don't work...

Any idea what gives? is there too much load resistance with the extra wire length for them to work?

Edit- nevermind, used too much solder, they work now...

Last edited by a moderator: Mar 5, 2009

This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.