Keyslot detail casting - anyone???

Does anyone know how the keyslot calc board castings are coming??

Anyone??

Nobody is replying to pm on the subject....


Pleeeeeeeeeaaaaase..... Pretty pleeeeeeeaaaaaase!

-Rod
 
I just finished making a mold for the keyslot detail. Pm me for more info.:)

Edit: Just to clarify, I made a mold for the KEYSLOTS, not the MQ-1 board found behind it.
 
This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top