Subscribe
  1. Member Since
    Jul 2013
    Posts
    70
    Sep 13, 2013, 8:21 AM - Key slot bubbles #1

    I recently got a helmet with resin bubbles (blobs) in the key slot by the mq1 board. Any guidance on how to remove these without damaging the bucket?
    Thanks!
  2. High Speed Low Drag Fett 4 Real's Avatar
    Member Since
    Jan 2010
    Posts
    5,584
    Sep 13, 2013, 9:31 AM - Re: Key slot bubbles #2

    Carefully...or cut them out and install an MQ1 casting....
  3. dolioshmolio's Avatar
    Member Since
    Jun 2013
    Posts
    406
    Sep 13, 2013, 10:19 AM - Re: Key slot bubbles #3

    i used a dremel rotary tool with a small engraving cutter bit.. its got a little ball on the end .. just find one that fits between the slots.. are you any good at the game operation?
  4. Member Since
    Jul 2013
    Posts
    70
    Sep 13, 2013, 10:45 AM - Re: Key slot bubbles #4

    Ha! I suppose we'll find out!
    That's no different than a regular dremel cutting tool with a different but on it, yes?
  5. dolioshmolio's Avatar
    Member Since
    Jun 2013
    Posts
    406
    Sep 13, 2013, 12:55 PM - Re: Key slot bubbles #5

    correct ... just a regular dremel ... and good luck.. just remember if it gets bad you can always do what Fett4Real suggested and cut them out and put in a MQ1 casting..

Similar Threads

  1. Key Slot Question now with Helmet Pic
    By supa troop in forum Boba Fett Helmet
    Replies: 11
    Last Post: Nov 1, 2011, 5:51 PM
  2. RotJ Ear & key slot technique
    By BlackCatBone in forum Boba Fett Helmet
    Replies: 3
    Last Post: Aug 21, 2011, 8:06 PM
  3. Regluing bubbles on action figure cards?
    By superjedi in forum The Sarlacc Pit
    Replies: 2
    Last Post: May 27, 2008, 2:37 PM
  4. cold cast alu stalk with bubbles?
    By terminal fettler in forum Prop Building Workshop
    Replies: 11
    Last Post: Mar 26, 2006, 11:15 AM