Interest - Range Finder

asok

Well-Known Hunter
If I where to make a new mold for the RF that I made in this thread
http://www.thedentedhelmet.com/showthread.php?t=24680
My current mold is trashed and I would need to make a new one. A kit would come with 3 parts, main body (cast in black resin), large clear part that goes inside the body, and a clear copy of the SX-70 lens. All parts would be cast in a pressure pot.

How many people would want one at $43 shipped.
 
Last edited by a moderator:
The stuff to make the mold has been ordered and some tint as well. So, I will offer them in black, white, and silver. My goal is to get the silicon by early next week and start the mold on the weekend.
 
Well I got the mold done! The new mold was made in the pressure pot as well. What do you think? I am going to be contacting

RFPic34.jpg


RFPic35.jpg


RFPic36.jpg
 
nice work as usual, brother! hey guys, got one of these kits for my mystery lid, and it was fantastic! i would be getting another, but my BM lid came with one...nice work Bill!
 
WORKS GREAT WITH MRGR8NESS LED BOARDS!!

Want to throw it out there that these RFs work GREAT with mrgr8ness LED boards!!

With just a bit of shaping to the clear view finder, the board fits like a charm! (y)
 
Last edited by a moderator:
This thread is more than 14 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top