AncientFett
Jr Hunter
I finally got my visor installed last night. Out of everything I've done on the helmet, that caused me the most pain. Anyway, its bolted in as most have done so it can be removed. I reget that I don't have any pictures yet but here's my question: when the visor is in should it fit tightly up against the inside of the helmet - ie the brow area and the mandibles? Looking at it from the outside, there is a small gap between the actual helmet and the visor. If I tighten the screws I'm afraid the helmet may crack from too much tension - its a fiberglass BM. I personally dont mind the gap. I'm just curious as to what everyone else does in this situation. This is my first attempt so theres a lot I don't yet.