How to install a tilt switch for the rangefinder LEDs?

Jgbeerman

New Hunter
I am making a cardboard helmet so looking for a cheap LED set up for the range finder. I think I am going to go with this kit (Electronic Rainbow Red Blinkey RB 2 | eBay) or something similar, however my issue is how to install a tilt switch. I feel confident in assembling the kit since it has directions, but completely zero idea when it comes to how/where to install the tilt switch.

Any information would be greatly appreciated! Thanks
 
You will need to hook the tilt switch up in series with the battery.
 
This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top