How do you remove RF on rubies

Jangos son

New Hunter
Hi ive got my helmet all painted up almost finished but for the RF i wanna sand it down and would like to know how to remove it and then put it back on thanks any input would be great
 
Lol, actually one day, the piece that goes on the outside to close the RF piece just broke off an it was nothing more the glued on, so I imagine it would be just as easy as using a screwdriver.
 
I used a heat gun on my old DP and a small screwdriver. Just remember that to much heat and you will warp the helmet.
 
This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top