Help needed-Quality brand/make/tint for ordering visors

syllander

Active Hunter
I have three helmets I will be working on in the near future. I plan on using the brad tee nut method for installation of the visors....BUT, does anyone know offhand a quality visor that could be ordered online, say from amazon or ebay? I don't know the thickness desired, but I definitely don't want one of those paper thin film visors. And smoke grey is the color of choice. What shade do you recommend? better to go with a 4 or go all the way to the 5 shade? Any help with a good brand/model is greatly appreciated.
 
Yeah what he said, I used a T-visor in that DP I resurrected from the dead. Nice quality, curve was perfect, just needed a little trimming in between lower mandibles
 
Extended, just expect to have a small amt to trim. Keep the segment of helmet cutout to overlay, and mark it up with proper amt of overhang. I'd also mask both sides with painters tape while it is being fit/trimmed.
 
This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top