Helmet Tutorial for ear pieces

Well lets see. You can glue them on using epoxy or bolt them on.

Now the ear part next to the RF stalk you can be high speed and use mangets.

I have a helemt that im working on now that I have to attach the ears to. Think im just going to glue.
 
i just slap some glue on the inside and press em on, then use some masking tape to hold them until the glue cures. not much to make a tutorial out of unfortunately :(
 
This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top