I was going to do something a bit radical with putting in my visor (sort of a replacement, taking it out of a 97 and putting it into a 96.) I was going to drill through the front of the mask and install small screws that would go through not only the helmet, but the visor as well, keeping it secure in place. Only problem is that I'm scared to drill into my mask. Once that happens, it can't unhappen.
(I kind of did this with the 97, but used small screws and screwed it in from inside the helmet, just far enough so the screws didn't actually go all the way through.)
So, what I was thinking was using some nylon fasteners and gluing (permanently) on the inside of the mask so that they would clip the visor into place. That way I could take the visor out if I needed, but I wouldn't have to get tools out to do it. The fasteners I'm thinking of are kind of like the motherboard standoff type, in nylon. I need to head down to Lowe's to check it out. Might have to check Home Depot too, but they're not as accessible here, plus I don't like the one here.
Any comments?