Helmet padding: what about this stuff?

Trooper TK409

Active Hunter
Anybody know where to get this stuff? I found it on ebay, but wondered if it's available cheaper at other places.

It was described as 1/2-inch dense black closed-cell foam securely affixed to an additional layer of 1/4-inch soft-as-down protective foam lining that is covered with velour fabric.You cut the padding strips to the desired lengths and attach to the inside of your helmet or armor with a hot-glue gun or Velcro.


fc_1_b.jpg


f7_1.jpg
 
I've seen similar foam at Hancock Fabrics, but not layered like that. It could be possible that the seller glued all three layers together himself.
 
This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top