Helmet Mods ::pictures::

Captain4434

Hunter
before10.gif
BEFORE
after10.gif
AFTER
The left cheek had a odd curve to it, when I cut the original t-visor out, it didn't not sit right on the new t-viosr, so I boiled that and straightened that out.the dome was too flat, again I boiled that and rounded it out.
Mvc-209a.jpg

A 1" x 1" CPU fan keeps the T-visor from fogging up.
come spring time I a plan on re-enforce the inside with fiberglass.
 
I assume that is a DP helmet? You did quite a good job on fixing those problems, it looks lots better. I would like to see a pic of the front of it.
 
This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top