Helmet dimensions

Josa Mereel

New Hunter
Right, i know i wouldn't be making a helmet (i'd be buying one) but i'm just curious about this. Ok, the top half of a bucket is round, but on the bottom only the rear of the helmet is round, and the font is angular, so, how does the front half get from round at the top to angular at the bottom???.......confusing, i know...

Joss
 
This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top