Fitting a T-Visor help / advice please...

Yup, my bucket is almost finished.
BUT I don't want to screw it up now by making a mess of fitting the spangly new T-Visor.

So, WHat's the best way to do it?
Build up the area around were it's going to make contact with the helmet to give more surface area for the glue to take hold with, or just glue it straight in place as is?

What kind of helmet is this? A Don Post, Rubies? Or perhaps is it a fiberglass mystery, bobamaker, or marrow sun?

Gods! sorry - It's a cheap assed Rubies.
I cut the old excuse for a T-Visor out with a dremel, bought a new T-visor from ebay (which looks like a good fit). Then painted the bucket.

Just did a quick search on visor install...

http://www.thedentedhelmet.com/showt...=visor+install

I would remove the old visor, paint the bucket, and then install the visor.

If you want it to fit perfectly flush then you can either use a dremel and make sure the area is perfectly sanded to perfection and then use Amazing goop(best glue ever, except for long drying time, or you can using little screws, I personally use both.

I just gooped my visor in. That stuff is, as it's title explains, AMAZING.

i used black silicone window sealer (used to fix leaks in a car windshield). it holds nicely, but isn't too bad to get the visor back out if you want to repaint it or something.

Goop is easy to remove too.

it's like super sticky hot glue that comes off with no residue.