First helmet build: Cardboard -Fibreglass

I began with the templates and a single sheet of posterboard today, mainly to see if I need to resize my bucket. It turns out that I have to resize the templates to cover up my jawline.

Does using two (or even three) layers of posterboard hold up against the fiberglass? I am worried about warping, as my mock up is a little flimsy, and am resonably sure I will end up with a mess. I don't care how many times I have to sand, to make a good finish.
 
This thread is more than 11 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top