first attempt at an ESB Buckett

monkey5150

Jr Hunter
Finally put some time into my first attempt at helmet.
PICT3803_zpse93a6527.jpg

Next up the back plates
 
sorry for my delay, just finished the back panels and now onto the dome

- - - Updated - - -

I still have a **** load of detailing but so far so "ok"
PICT3806_zpsae889d1c.jpg

PICT3807_zpscce615ae.jpg
 
Last edited by a moderator:
To me it looks like you have the stencils scaled to large for the helmet...or your tracing outside the lines and then going to large with the liquid masking fluid.
 
f4real you called it, I really screwed the dome up this week end. I didnt even realize it until it was too late, just like you said. My dent looks like a bazooka hit it. :( I will post some wips tonight afterwork but I may have to just strip and repaint it ughhhh.
 
f4real you called it, I really screwed the dome up this week end. I didnt even realize it until it was too late, just like you said. My dent looks like a bazooka hit it. :( I will post some wips tonight afterwork but I may have to just strip and repaint it ughhhh.

Even if you have to looks as if you have a feel for the painting method, I will be watching this tread as i will be in the same boat soon,Good job
 
This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top