finished my helmet; at last!

terminal fettler

Active Hunter
Its done, just need to find a chin strap so my (large?) nose dosent touch the visor...:lol:

DSCF0001_55.jpg


DSCF0018_6.jpg


DSCF0020_9.jpg


DSCF0012_11.jpg
 
Insane attention to detail. I love the blast streaks coming from the dent, and the hundreds of surface scratches. Well done!
 
Mate this is an insane amount of detail... I'm happy to have seen pics on this... I can't wait for mine to arrive so I too can venture into the ESB look.
And I could not think of a better way to spend my 400th Post!! (y)
Awesome work G... :love
 
oooohhhhh!!!!! Thats a dandy!!!!! Especially love the job you did on the back!!!! Post some more pics of that bad boy!!
D
 
fettler...i was wondering where you picked up those foam pieces for the liner...
The foam liner comes from packaging for sram xo shifters and derailleurs. Approx. 10mm thick, i laminated it with carpet tile adhesive spray to the right thickness, just added the extra squares for additional padding. The peices are then held into the helmet with self adhesive velcro strips.
 
Way to go TF. That is seriously one sweet bucket. The attention to detail from the foam to the wiring to the visor is first rate. Makes me want to get back on mine!(y)
 
The foam liner comes from packaging for sram xo shifters and derailleurs. Approx. 10mm thick, i laminated it with carpet tile adhesive spray to the right thickness, just added the extra squares for additional padding. The peices are then held into the helmet with self adhesive velcro strips.

It seems like the only place to find foam pieces like that is in packaging for hardware...you can't really buy it separate.
 
It seems like the only place to find foam pieces like that is in packaging for hardware...you can't really buy it separate.

Hey Chad,
I got some similar foam for my gauntlets at Ace Hardware. It's weatherstripping foam. Like TF said, if you use some of the 3M spray adhesive, you can layer it or just lay strips next to each other till you get the shape or thickness you want.
Worth taking a look. :)

Another thing I did recently for an X-Wing pilot helmet was to buy a cheap batting helmet and cut the foam pads out. I used the same spray adhesive to put into my helmet.
 
It seems like the only place to find foam pieces like that is in packaging for hardware...you can't really buy it separate.

Go to a bike shop and ask for some packaging for components, a good bike shop normally builds the bikes there so they should have plenty of boxes with the foam left over.
 
This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top